Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 140)

User Interface Display Options
Page 4-30
User Interface Display Options
The System menu several commands to configure help information, character display, and the
system prompt for the
UI . Enter
system
at the system prompt to enter the System menu. Press the question mark ( ? ) to see the System
menu commands, as shown below.
Command System Menu
info Basic info on this system
dt Set system date and time
ser View or configure the DTE or DCE port
mpm Configure a Management Processor Module
slot View Slot Table information
systat View system stats related to system, power and environment
taskstat View task utilization stats
memstat View memory use statistics
fsck Perform a file system check on the flash file system
newfs Erase all files from /flash & create a new file system
syscfg View/Configure info related to this system
uic UI configuration; change - prompt, timeout, more, verbose.
camstat View CAM info and usage
camcfg Configure CAM info and usage
hrex Enter HRE-X management command sub-menu
ver/ter Enables/disables automatic display of menus on entry (obsolete,
use ‘uic’ command)
echo/noecho Enable/disable character echo
chpr Change the prompt for the system (obsolete, use ‘uic’ command)
logging View system logs.
health Set health parameters or view health statistics
cli/exit Enter command line interface
saveconfig Dump the cache configuration content to the mpm.cfg file.
cacheconfig Set the flag to use cache configuration only.
Main File Summary VLAN Networking
Interface Security System Services Help
For information on the info , dt , ser , slot , systat , taskstat , memstat , fsck , newfs , syscfg , camstat ,
camcfg , and hrex commands, refer to Chapter 9, “Switch-Wide Parameters.” The mpm
command is described in Chapter 6, “Configuring Management Processor Modules.” The ver/
ter and chpr commands are described earlier in Setting Verbose/Terse Mode for the User
Interface on page 4-22. The echo/noecho command is described in the following section. The
cli command is described earlier in Changing Between the CLI and UI Modes on page 4-2.
The logging command is described in Chapter 10, “Switch Logging.”
♦ Note ♦
The ver / ter , and chpr commands now appear as items
in the UI Configuration menu (displayed through the
uic command). If you enter the ver / ter and chpr
commands, a message will advise you to use the uic
command, and the UI Configuration menu will auto-
matically display. For more information on the UI
Configuration menu, refer to The UI Configuration
Menu on page 4-17.