Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 1021)

Backup Services Commands
Page 34-11
Viewing Backup Service(s) Configurations
With the bsview command, you can view the configuration of either all backup services, or a
single backup service.
Viewing the Configurations of All Backup Services
To view the configurations for all backup services, enter the following command, followed by
, at the prompt:
/ Interface/backup % bsv
A screen similar to that shown below will display:
Backup Table Entries
Slot/
Primary Port/ Bkup Peer Strup Act.Rest.
Idx Description Type DLCI Type Id Time Time Time
=== ======================== ======= ====== ==== ==== ==== ==== ====
1 Backup 1 PHYPORT 2/1 PPP 5 300 10 10
2 Backup 2 FR PVC 3/3/32 PPP 1 300 10 10
3 Backup of PVC to Chicago FR PVC 3/3/33 PPP 7 300 0 60
Viewing the Configuration of a Single Backup Service (bsview Command)
To view the configuration for a single backup service, enter the bsview command followed by
the index number of the backup service, followed by , as shown in the example
below:
/Interface/backup % bsv 2
A screen similar to that shown below will display:
Backup Table Entries
Slot/
Primary Port/ Bkup Peer Strup Act.Rest.
Idx Description Type DLCI Type Id Time Time Time
=== ======================== ======= ====== ==== ==== ==== ==== ====
1 Backup 1 Port 3/3/32 Peer 1 300 10 10
Deleting a Backup Service
Use the bsdelete command to delete a backup service. Deleting a backup service will delete
the backup service configuration record. If a backup is enabled (e.g. due to the primary entity
being down), the backup entity will be brought down (e.g., for ISDN the call will be discon-
nected).
To delete a backup service, enter the bsdelete command followed by the index number of the
backup service, followed by , as shown in the example below:
/ % bsdelete 2
A screen similar to that shown below will display.
This will bring down Backup (if up) and delete Backup Service Record
Index
: 1
Description : Backup 1.
Continue? {(Y)es, (N)o} (N) :
Enter or N (the default value) to cancel the command. Enter Y to delete the backup
service