Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 296)

NTP Information Menu
Page 12-18
Display Detailed Information for One or More Peers
The ntpshowpeer command allows you to view detailed NTP information about any remote
associations of this switch. To view detailed NTP information about a remote association enter
the ntpshowpeer command in the following manner:
ntpshowpeer
where is the either the domain name or IP address of the remote association. For
example, to show information for a peer with IP address 1.1.1.4, enter:
ntpshowpeer 1.1.1.4
A screen similar to the following is displayed:
remote 1.1.1.4, local 0.0.0.6
hmode sym_active, pmode server, stratum 16, precision -7
leap 11, refid [0.0.0.0], rootdistance 0.00000, rootdispersion 0.00000
ppoll 6, hpoll 6, keyid 0, version 3, association 41807
valid 0, reach 000, unreach 0, flash 000, boffset 0.00391, ttl/mode 0
timer 32s, flags config, bclient
reference time:
00000000.00000000 Thu, Feb 7 1936 6:28:16.000
originate timestamp: 00000000.00000000 Thu, Feb 7 1936 6:28:16.000
receive timestamp: 00000000.00000000 Thu, Feb 7 1936 6:28:16.000
transmit timestamp: 00000000.00000000 Thu, Feb 7 1936 6:28:16.000
filter delay: 0.00000 0.00000 0.00000 0.00000
0.00000 0.00000 0.00000 0.00000
filter offset: 0.000000 0.000000 0.000000 0.000000
0.000000 0.000000 0.000000 0.000000
filter order: 7 6 5 4
3 2 1 0
offset 0.000000, delay 0.00000, dispersion 16.00000, selectdisp 0.00000
It is possible to display information from more than one remote association by adding more
addresses when entering the
ntpshowpeer command. For example, to display information on a
peer with IP address 1.1.1.4 and a peer with IP address 1.1.1.5, enter:
ntpshowpeer 1.1.1.4 1.1.1.5
Field Descriptions
The following section describes the fields displayed using the ntpshowpeer command.
Remote . The IP address of the remote association.
Local . The local interface address assigned by NTP to the remote association. If this address is
0.0.0.0 , then the local address has yet to be determined.
Hmode . The host mode of this remote association. There are five possible modes: symmetric
active, symmetric passive, client, server, and broadcast. The displayed mode is assumed if this
association becomes the switch’s host
NTP server. For a description of the modes, see Display
List of Peers the Server Knows About on page 12-15. For a description of how to set a switch
host
NTP server, see Specify the Host Whose NTP Server We Talk To on page 12-34.
Pmode . The peer mode of this remote association. There are five possible modes: symmetric
active, symmetric passive, client, server, and broadcast. The displayed mode is assumed if this
association becomes the switch’s host
NTP server. For a description of the modes, see Display
List of Peers the Server Knows About on page 12-15. For a description of how to configure a
peer, see Configuring a New Peer Association on page 12-12
Stratum . The stratum level of the remote peer. If this number is 16 , the remote peer has not
been synchronized.