Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 266)

Displaying the Connection Entries in the MPM Log
Page 10-10
Displaying the Connection Entries in the MPM Log
The conlog command displays a list of connections made since console event, FTP , or Telnet
logging was activated by the swlogc command (described in Configuring Switch Logging on
page 10-6). To display this data, enter
conlog
at the system prompt. A screen similar to the following will be displayed.
User Line Peer Start Finish
-------- ----------- --------------- ---------------- ------------------
admin Telnet 198.206.187.113 08/14/00 09:47 - 09:47 (00:00)
admin Telnet 198.206.187.113 08/20/00 09:47 - 09:53 (00:05)
admin Telnet 198.206.187.113 08/20/00 09:55 - 10:00 (00:05)
admin console 08/20/00 10:35 logged in (00:27)
admin Telnet 198.206.187.113 08/20/00 11:02 logged in (00:00)
The fields displayed by the conlog command are described below.
User . The name of the user who made the connection to the switch.
Line . The login type of connection to the switch (e.g., a Telnet or console port connection).
Peer . If the user was connected through Telnet, then the IP address of the user will be
displayed. If the user was connected through the console port, then this field will be blank.
Start . The time that the connection started.
Finish . Displays the time the connection terminated or logged in for sessions that are still
current. The value in parenthesis is the duration of the session, in minutes.