Yaskawa G5HHP Drive User Manual
Yaskawa Equipment
Table of contents
Document Outline
- Cover
- Preface
- Safety Information
- Visual Aids
- General Precautions
- Safety Precautions
- Warning Label Contents and Position
- Definition of Terms
- How to Change the Digital Operator Display from Japanese to English
- Table of Contents
- Introduction
- Handling Inverters
- Wiring
- Setting User Constants
- Trial Operation
- Basic Operation
- 6.1 Common Settings
- 6.1.1 Setting the Access Level and Control Method: A1-01, A1-02
- 6.1.2 Frequency Reference Settings: b1-01, H3-01, H3-08, H3-09
- 6.1.3 Frequency Reference from Digital Operator: b1-01, o1-03, d1-01 to d1-09
- 6.1.4 Run Source and Sequence Input Responsiveness: b1-02, b1-06, b1-07
- 6.1.5 Acceleration/Deceleration Times: C1-01 through C1-08, C1-09, C1-10, C1-11
- 6.1.6 Prohibiting Reverse Operation: b1-04
- 6.1.7 Selecting the Stopping Method: b1-03
- 6.1.8 Multi-function Input Settings: H1-01 through H1-06
- 6.2 Open-loop Vector Control
- 6.3 V/f Control
- 6.4 Flux Vector Control
- 6.5 V/f Control with PG
- 6.1 Common Settings
- Advanced Operation
- User Constants
- 8.1 Initialize Mode Constants
- 8.2 Programming Mode Constants
- 8.2.1 Application Constants: b
- 8.2.2 Autotuning Constants: C
- 8.2.3 Reference Constants: d
- 8.2.4 Motor Constant Constants: E
- 8.2.5 Options Constants: F
- 8.2.6 Terminal Constants: H
- 8.2.8 Operator Constants: o
- 8.2.9 Factory Settings that Change with the Control Method (A1-02)
- 8.2.10 Factory Settings that Change with the Inverter Capacity (o2-04)
- Troubleshooting
- 9.1 Protective and Diagnostic Functions
- 9.2 Troubleshooting
- 9.2.1 If Constant Constants Cannot Be Set
- 9.2.2 If the Motor Does Not Operate
- 9.2.3 If the Direction of the Motor Rotation is Reversed
- 9.2.4 If the Motor Does Not Put Out Torque or If Acceleration is Slow
- 9.2.5 If the Motor Does Not Operate According to Reference
- 9.2.6 If the Slip Compensation Function Has Low Speed Precision
- 9.2.7 If There is LowSpeed Control Accuracy at High-speed Rotationin Open-loopVec-tor Control Mode
- 9.2.8 If Motor Deceleration is Slow
- 9.2.9 If the Motor Overheats
- 9.2.10 If There is Noise When the Inverter is Started or From an AM Radio
- 9.2.11 If the Ground Fault Interrupter Operates When the Inverter is Run
- 9.2.12 If There is Mechanical Oscillation
- 9.2.13 If the Motor Rotates Even When Inverter Output is Stopped
- 9.2.14 If 0 V is Detected When the Fan is Started, or Fan Stalls
- 9.2.15 If Output Frequency Does Not Rise to Frequency Reference
- Maintenance and Inspection
- Specifications
- Appendix
- Indexes
- Rear Cover