Yaskawa G5HHP Drive - Manual (Page 73)

4.2 Modes
4 - 5
4.2.2 Switching Modes
Once the Inverter has been put into operation mode by pressing the Menu Key, the Increment and Decrement
Keys can be pressed to switch to other modes. Press the DATA/ENTER Key to read/set the user constants
in each mode.
Press the ESC Key to return to the mode display from the user constant display.
Press the DATA/ENTER Key twice to write a constant and then press the ESC Key to return to the mode
display. This is the most Basic operation, so you should remember it.
All modes/constant
status
G5* Main Menu*
Operation
G5* Main Menu*
Initialize
G5* Main Menu*
Programming
G5* Main Menu*
Autotuning
G5* Main Menu*
Modified Consts
Power ON
Frequency Ref
U1--01 = 0.00 HZ
Select Language
English
Reference Source
Terminal
Rated Voltage
400.0 VAC
None Modified
MENU
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
A1--00 = 1***
English
Function b1
Sequence
Rated Voltage
400.0 VAC
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
Operation mode
Initialize mode
Programming mode
Autotuning mode
(Open loop vector control at factory
setting.)
Modified constant mode
(Mode Display)
Monitor (Frequency reference value)
Operator display language selection
Frequency reference input method
selection
Display contents differ depending on the
access level (A1-01)
Autotuning
(Rated voltage setting)
Displays constants changed
from factory settings
Function
(Constant Reading)
Constant Display
(Constant Setting)
(Access level: Quick-start)
Fig 4.3 Mode Transitions
4