Yaskawa G5HHP Drive - Manual (Page 220)

Advanced Operation
7.5.4 Option Constants: F
7 - 56
7.5.4 Option Constants: F
J
Installing Option Cards
A maximum of three Option Cards can be installed in the Inverter. The installation location of each is deter-
mined by the type of Card. Be sure to install the Cards in their correct locations.
Constants of the Option Cards can be referred or set with the access level Basic.
Table 7.7 Option Card Specifications
Type of card Model Specifications Location
Analog Reference Card
AI-14U 14-bit analog, 2 inputs (voltage/current) C
Analog Reference Card
AI-14B 14-bits analog, 3 inputs C
Digital Reference Card
DI-08 8-bit digital input (BCD/binary) C
Digital Reference Card
DI-16H2 16-bit digital input (BCD/binary) C
PG-A2 Open-collector/complementary, single input A
PG Speed Control Card
PG-B2 Complementary, A/B-phase input A
PG Speed Control Card
PG-D2 Line-driver, single input A
PG-X2 Line-driver, A/B-phase input A
Analog Monitor Card
AO-08 8-bit analog output, 2 channels D
Analog Monitor Card
AO-12 12-bit analog output, 2 channels D
Pulse Monitor Card PO-36F Pulse frequency output D
Installation Procedure
Use the following procedure to install a PG Speed Control Card.
1. Turn OFF the main-circuit power supply of the Inverter Panel.
2. Leave it OFF for at least five minutes before opening the front panel of the Inverter Panel. Check to be
sure that the CHARGE lamp is OFF.
7