Yaskawa G5HHP Drive - Manual (Page 31)

2.3 Transportation
2 - 5
2.3.3 Transporting on Rollers
When transporting the Inverter Panel using rollers, carefully push the Inverter Panel so as not to distort the frame
or damage the Inverter Panel surface.
D
Use rollers equivalent to gas pipes with an approx. diameter of 30 to 50 mm. The length should be such
that the rollers extend beyond the Inverter Panel on both sides by approx. 100 mm.
D
When the Inverter Panel has been moved to a desired location, carefully lift the Inverter Panel with a
lifting bar and remove the rollers. Insert the lifting bar at the four corners of the box as shown in Fig-
ure 2.4.
When inserting a lifting bar under the door, be careful not to damage the door with the lifting bar.
Fig 2.4 Lifting Bar Insertion Locations
2