Yaskawa G5HHP Drive - Manual (Page 244)

Advanced Operation
7.5.5 External Terminal Functions: H
7 - 80
Terminal 39 input gain H3-10
Terminal 39 input bias H3-11
D
When a voltage input is being input to terminal 39, be sure to disconnect jumper wire J1 on the control
PC board.
D
The input resistance will be destroyed if a voltage input is used without disconnecting the jumper wire.
(Refer to Torque Reference Settings: H3-04, H3-05, H3-08, H3-09 in 7.3.3.)
D
Set the time constant in constant H3-12 when adding a primary delay filter to an analog input. This filter
time constant applies to all three of the analog inputs.
7