Yaskawa G5HHP Drive - Manual (Page 221)

7.5 Common Functions
7 - 57
3. After aligning to the Option-A connector on the control PCB located on the back of the front door of
the Inverter Panel, pass the spacer through the spacer hole at the Card. (Refer to A in the illustration.)
Check to be sure that it is precisely aligned with the 4CN position, and snap it into the proper position.
Be sure to press it in firmly until you hear it snap into place.
Ground terminal
Option A Option CD
Option C
Control
board
Option D
4CN
Option-A
Connector
2CN
Option-C
Connector
3CN
Option-D
Connector
Spacer
[Front] (Side)
PG Speed
Control
Card
Spacer
PG Speed
Control
Card
Top
Bottom
Fig 7.29 Installing a PG Speed Control Card 7