Yaskawa G5HHP Drive - Manual (Page 241)

7.5 Common Functions
7 - 77
Constant Settings
User
Change
during Setting Factory
Valid Access Levels
User
Constant
Number
Name
g
during
Opera-
tion
Setting
Range
Unit Factory
Setting V/f
Control
V/f with
PG
Open
Loop
Vector
Flux
Vector
H2-01
Multi-function input
(terminal 53-57)
x 0 to 37 -- 0 B B B B
H2-02
Multi-function input
(terminal 19)
x 0 to 37 -- 1 B B B B
H2-03
Multi-function input
(terminal 20)
x 0 to 37 -- 2 B B B B
D
The following table shows the settings and section references for functions that are described in more
detail in this chapter.
Function Setting Section
Frequency Agree 1 2
Desired Frequency Agree 1 3
Frequency Detection Settings: L4-01 to L4-05 in
Frequency Detection 1 4
Frequency Detection Settings: L4-01 to L4-05 in
7.5.6
Frequency Detection 2 5
Overtorque Detection 1 (NO) B
Overtorque Detection Settings: L6-01 to L6-06 in
7.5.6
Loss of Frequency Reference C
Timer Functions: b4 01 b4 02 in 7 5 1
Timer Function Output 12
Timer Functions: b4-01, b4-02 in 7.5.1
Frequency Agree 2 13
Desired Frequency Agree 2 14
Frequency Detection Settings: L4-01 to L4-05 in
Frequency Detection 3 15
Frequency Detection Settings: L4-01 to L4-05 in
7.5.6
Frequency Detection 4 16
Overtorque Detection 1 (NC) 17
O D i S i L6 01 L6 06 i
Overtorque Detection 2 (NO) 18
Overtorque Detection Settings: L6-01 to L6-06 in
7.5.6
Overtorque Detection 2 (NC) 19
7.5.6
D
Refer to Table 7.10 Multi-function Output Functions for information on the following functions.
Function Setting
Inverter Operation Ready 6
DC Bus Undervoltage 7
During Baseblock 8
Frequency Reference Selection 9
Run Command Selection A
Braking Resistor Fault D
Fault E
Minor Fault 10
Fault Reset Command Active 11
During Reverse Run 1A
During Baseblock 2 1B
Regenerating 1D
Restart Enabled 1E
During Torque Limit (Current Limit) 30
During Speed Limit 31
7