HEIDENHAIN TNC 406 - Manual (Page 6)

HEIDENHAIN TNC 406, TNC 416 I
TNC Models, Software and Features
This manual describes functions and features provided by the TNCs as
of the following NC software numbers.
Location of use
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
New features of the NC software 280 62x-xx and
280 180-xx
„ Cycle 14 CONTOUR GEOMETRY (see also ”Cycle 14 CONTOUR
GEOMETRY” on page 137)
„ Q parameters for the roughness (see also ”Data from the erosion
table” on page 203)
„ Q parameters for the gap size (see also ”Gap size LS max when
machining which Cycle 1 GENERATOR: Q164” on page 206)
„
After manual traverse, the incremental coordinates always refer to
the actual position (see also ”Resuming program run with the
GOTO key” on page 226)
„ Expansion of the tool table with tool pocket number, tool undersize
and radius (see also ”Entering electrode data in tables” on page 74)
„ Probed values can be written to a datum table as well as to a tool
table (see also ”Writing probed values to tables” on page 28)
„ Enhancement of functions FN14 and FN15 (see also ”Output of Q
Parameters and Messages” on page 197)
„ M108/M109 (see Overview of Miscellaneous Functions on the
inside rear cover of this manual)
TNC Model NC Software No.
TNC 406 280 620-12
280 621-12
280 622-12
TNC 416 286 180-06