HEIDENHAIN TNC 406 - Manual (Page 244)

HEIDENHAIN TNC 406, TNC 416 223
1
1
.3 Pr
ogr
a
m r
u
n Running a part program
Preparation
1 Clamp the workpiece to the machine table.
2 Set the datum.
Program Run, Full Sequence
8 Start the part program with the machine START button.
Program Run, Single Block
8 Start each block of the part program individually with the machine
START button.
Interrupting machining
There are several ways to interrupt a program run:
„ Programmed interruptions
„ Machine STOP button
„
Switching to PROGRAM RUN, SINGLE BLOCK
If the TNC registers an error during program run, it automatically
interrupts the machining process.
Programmed interruptions
You can program interruptions directly in the part program. The TNC
interrupts the program run at a block containing one of the following
entries:
„ STOP
„ Miscellaneous function M0, M2 or M30
„
Miscellaneous function M6 (determined by the machine tool builder)