HEIDENHAIN TNC 406 - Manual (Page 239)

218 11 Test run and Program Run
1
1
.1 Gr
aphics
To rotate the 3-D view
Shift the soft-key row until the following soft keys appear:
The current angle of rotation of the display is shown at the bottom left
of the graphic.
Switch the frame overlay display for the workpiece blank on/off:
8 Show the frame overlay with SHOW BLK-FORM
8 Omit the frame overlay with OMIT BLK-FORM
Magnifying details
You can magnify details in the Test Run mode in the following display modes:
„ Projection in three planes
„
3-D view
The graphic simulation must first have been stopped. A detail
magnification is always effective in all display modes.
Shift the soft-key row in the Test Run mode of operation until the
following soft keys appear:
To change the detail magnification:
The soft keys are listed in the table above.
8 Interrupt the graphic simulation, if necessary.
8 Select the workpiece surface with the corresponding soft key (see table).
8 To reduce or magnify the blank form, press and hold the MINUS or
PLUS soft key, respectively.
8 Restart the test run or program run by pressing the START soft key
(RESET + START returns the workpiece blank to its original state).
Function Soft keys
Rotate the workpiece in 27° steps
about the vertical axis
Function Soft keys
Select the left/right workpiece surface
Select the front/back workpiece surface
Select the top/bottom workpiece surface
Shift the sectional plane to reduce or
magnify the blank form
Select the isolated detail