HEIDENHAIN TNC 406 - Manual (Page 24)

HEIDENHAIN TNC 406, TNC 416 3
1
.2 V
isual Displa
y Unit and K
e
yboar
d 1.2 Visual Display Unit and
Keyboard
Visual display unit
The TNC 406 is delivered with the BC 110 color monitor (CRT); the
TNC 416 can be delivered with the BC 120 color monitor (CRT) or the
BF 120 flat-screen color monitor (TFT). The figure at top right shows
the keys and controls on the BC 120, and the figure at bottom right
shows those of the BF 120.
Keys on BC 120 only
1 Header
When the TNC is on, the selected operating modes are shown in
the screen header.
2 Soft keys
In the footer the TNC indicates additional functions in a soft-key
row. You can select these functions by pressing the keys
immediately below them. The lines immediately above the soft-
key row indicate the number of soft-key rows that can be called
with the black arrow keys to the right and left. The line
representing the active soft-key row is highlighted.
3 Soft key selector keys
4 Switching the soft-key rows
5 Setting the screen layout
6 Shift key for switchover between machining and programming
modes
1 3
1 1
2
4 4
5 1 6 7 8 9 10
2
1
11 4 3 1 5 1 4 6
7 Screen demagnetization; Exit main menu for screen settings
8 Select main menu for screen settings:
„
In the main menu: Move highlight downward
„
In the submenu: Reduce value or move picture to the left or
downward
9 „ In the main menu: Move highlight upward
„
In the submenu: Increase value or move picture to the right or
upward
10 „ In the main menu: Select submenu
„
In the submenu: Exit submenu
Main menu dialog Function
BRIGHTNESS Adjust brightness
CONTRAST Adjust contrast
H-POSITION Adjust horizontal position
V-POSITION Adjust vertical position
V-SIZE Adjust picture height