4 p ath cont ours — car tesian coor dinat es – HEIDENHAIN TNC 406 User Manual
Page 126

HEIDENHAIN TNC 406, TNC 416
105
6.4 P
ath Cont
ours — Car
tesian Coor
dinat
es
16 L Y+5 R F M
Point 4: 2nd straight line for corner 3, 1st straight line for corner 4
17 L 20
Program chamfer with length 20 mm
18 L X+5 R F M
Move to last contour point 1, second straight line for corner 4
21 L X–10 Y–10 R0 F M37
Retract tool in the working plane; eroding OFF
20 L Z+100 F MAX
Move electrode to set-up clearance; rapid traverse
21 END PGM LINEAR MM
End of program
This manual is related to the following products: