9 q p ar amet ers with special f u nctions – HEIDENHAIN TNC 406 User Manual
Page 226

HEIDENHAIN TNC 406, TNC 416
205
1
0.9 Q P
ar
amet
ers with Special F
u
nctions
Dimensions in the erosion table: Q114
Coordinates after probing during program run: Q115 to Q119
The parameters Q115 to Q119 contain the coordinates of the spindle
position in the machine system at the moment of contact during
programmed measurement with the probing electrode.
The length and radius of the probing electrode are ignored in these
coordinates:
Coordinates after probing during program run: Q120 to Q124
The parameters Q120 to Q124 contain the coordinates of the spindle
position in the workpiece system at the moment of contact during
programmed measurement with the probing electrode.
The length and radius of the probing electrode are ignored in these
coordinates:
Dimensions in the erosion table
Parameter value
Directly after table selection
Q114 = –1
Metric system (mm)
Q114 = 0
Inch system (inches)
Q114 = 1
Coordinate axis
Parameter
X axis
Q115
Y axis
Q116
Z axis
Q117
IVth axis
Q118
Vth axis
Q119
Coordinate axis
Parameter
X axis
Q120
Y axis
Q121
Z axis
Q122
IVth axis
Q123
Vth axis
Q124