beautypg.com

Running a program test up to a certain block, Operating time, 2 t e st r u n – HEIDENHAIN TNC 406 User Manual

Page 242

background image

HEIDENHAIN TNC 406, TNC 416

221

1

1

.2 T

e

st r

u

n

Running a program test up to a certain block

If you only want to test the program up to a particular block:

8

Choose the program you want to test.

8

Press the soft key STOP AT N.

8

Enter the block number up to which the TNC should

run a program test.

8

If the block is located in a different program, enter the

PROGRAM.

8

If the block number is located within a program section

repeat, enter the REPEATS.

8

Start the test run with START.

Operating time

The TNC displays the simulation time between the program blocks
and the status display.

This manual is related to the following products: