beautypg.com

4 p ath cont ours — car tesian coor dinat es – HEIDENHAIN TNC 406 User Manual

Page 123

background image

102

6 Programming: Programming Contours

6.4 P

ath Cont

ours — Car

tesian Coor

dinat

es

„

For a full circle, two CR blocks must be programmed in
succession.

„

The distance from the starting and end points of the arc
diameter cannot be greater than the diameter of the arc.

„

The maximum radius is 30 m.

„

You may not enter rotary axes A, B or C.

This manual is related to the following products: