HEIDENHAIN TNC 406 - Manual (Page 262)

HEIDENHAIN TNC 406, TNC 416 241
12.6 Ent
e
r Axis T
ra
v
e
rse Limits
„ The tool radius is not automatically compensated in the
axis traverse limit value.
„ The traverse range limits and software limit switches
become active as soon as the reference points are
traversed.
„ The TNC checks whether the negative limit is less than
the positive limit in each axis.
„
You can also transfer the reference points directly,
using actual position capture.
„ You can re-establish the last stored value with the
NO ENT key.
„ You can re-establish the axis limits stored in the
machine parameters with the TRANSFER FROM MP
soft key.