HEIDENHAIN TNC 406 - Manual (Page 248)

HEIDENHAIN TNC 406, TNC 416 227
1
1
.3 Pr
ogr
a
m r
u
n Resetting the counters
To reset the counters of program section repeats after you resume
program run:
8 Use GOTO 0 to return to the beginning of the program.
If you do not wish to reset the counters:
8 Use GOTO > 0 to go to a certain block.
Time capture table TIME.W
The time capture table TIME.W in the TNC contains the following
columns:
„ PS: Power stage number
„
ETABLE: Erosion table name
„ TOOL: Tool number
„ REL.: Erosion time per power stage
„ ABS.: Total erosion time
„ DATUM: Datum table name
„
NR: Datum number
„ PROGRAM: Program name
„ BLOCK: Block number
The TNC automatically writes the above data to TIME.W when a new
generator setting is transmitted to the PLC during program run. The
time table therefore receives as many lines as there are power stages
programmed.
To display TIME.W
8 Select the operating mode PROGRAMMING AND EDITING.
8 Press the PGN NAME key.
8 Enter ”TIME”.
Resetting TIME.W
The TNC automatically overwrites TIME.W when you select a new
program in a program run mode of operation or press the RESET soft
key.