HEIDENHAIN TNC 406 - Manual (Page 273)

252 13 Tables and Overviews
13.1 Gener
a
l User P
ar
amet
ers
Effect of axis IV in the datum table MP7411
IVth coordinate with datum from table rotates coordinate system and
shifts in C: 0
IVth coordinate with datum from table shifts in C (no rotation): 1
Effect of CYCL CALL after CYCL DEF 12 PGM
CALL MP7412
The program defined as a cycle is executed without display of NC blocks;
local Q parameters are stored: 0
The program defined as a cycle is executed with display of NC blocks;
local Q parameters are not stored: 1
Does not apply as of NC 28612x-04/28062x-10.
Behavior of M functions MP7440
Program stop with M06: +0
No program stop with M06: +1
No cycle call with M89: +0
Modal cycle call with M89: +1
Maximum permissible angle of directional
change for constant contouring speed
(effective for corners with R0 and for all
inside corners). MP7460
0.0000 to 179.999 [°]
Monitoring limit switches in the TEST RUN
mode of operation MP7491
Monitoring limit switches active: 0
Monitoring limit switches not active: 1
Override behavior
Set overrides MP7620
Feed rate override,
if rapid traverse key is pressed in program run mode
Override effective: +1
Override not effective: +0
Steps for overrides
2% steps: +0
1% steps: +2
Feed rate override,
if rapid traverse and external direction axis direction button pressed
Override effective: +4
Override not effective: +0
Electronic handwheels
Set interpolation error MP7670.0
Slow handwheel interpolation error: 0...10
MP7670.1
Medium handwheel interpolation error: 0...10
MP7670.2
Fast handwheel interpolation error: 0...10
TNC displays, TNC editor