HEIDENHAIN TNC 406 - Manual (Page 225)

204 10 Programming: Q Parameters
1
0.9 Q P
ar
amet
ers with Special F
u
nctions
Electrode axis Q109
The value of parameter Q109 depends on the current tool axis:
Miscellaneous functions for free rotation of the C axis: Q110
The value of parameter Q110 depends on which M function was last
programmed for the rotation of the C axis:
Flushing: Q111
Plane of rotation during ROTATION Cycle: Q112
Dimensions of the main program: Q113
Tool axis Parameter value
No tool axis defined Q109 = -1
Z axis Q109 = 2
Y axis Q109 = 1
X axis Q109 = 0
Definition of miscellaneous functions Parameter value
No M3, M4 or M5 defined Q110 = –1
M03: Free rotation of C axis ON Q110 = 0
M04: Free rotation of C axis OFF Q110 = 1
M05 active Q110 = 2
M functions Parameter value
Directly after program selection Q111 = –1
Flushing OFF (M09 active) Q111 = 0
Flushing ON (M08 active) Q111 = 1
Plane of rotation Parameter value
No plane defined Q112 = –1
Y/Z plane Q112 = 0
Z/X plane Q112 = 1
X/Y plane Q112 = 2
Dimensions of the main program Parameter value
Directly after program selection Q113 = –1
Metric system (mm) Q113 = 0
Inch system (inches) Q113 = 1