HEIDENHAIN TNC 406 - Manual (Page 142)

HEIDENHAIN TNC 406, TNC 416 121
7.
1 Ent
er
ing Miscellaneous F
u
nctions M and S
T
OP
The program run or test run is interrupted when the NC block
containing the STOP function is reached.
You can also enter an M function in a STOP block.
If the program run is to be interrupted for a specified time, use Cycle
9 DWELL TIME (see also ”DWELL TIME (Cycle 9)” on page 171).
Enter STOP function
Select STOP function.
If desired: Enter miscellaneous function, e.g. M6
(electrode change).
Example NC block
MISCELLANEOUS FUNCTION M ?
7 STOP M6
6