beautypg.com

2 cycle 1 generator, Working with an erosion table, Working without an erosion table – HEIDENHAIN TNC 406 User Manual

Page 154: To enter cycle 1.0 generator

background image

HEIDENHAIN TNC 406, TNC 416

133

8.2 Cy

cle 1 GENERA

T

O

R

8.2 Cycle 1 GENERATOR

Working with an erosion table

Program the following information in this cycle:

„

Which erosion table P-TAB you want to use

„

The maximum power stage MAX for subsequent machining

„

The minimum power stage MIN for subsequent machining

In a program run operating mode the TNC displays the highest and
lowest power stage after the GENERATOR cycle has been executed.

Working without an erosion table

If you are not working with an erosion table, do not copy Cycle 1.0
GENERATOR into the program. In this case you must enter the
erosion parameters in Q parameters Q90 to Q99.

To enter Cycle 1.0 GENERATOR

Open the cycle directory.

Open selected cycle.

Enter name of the erosion table, e.g. 5.

Enter the highest power stage for machining, e.g. 15.

Enter the lowest power stage for machining, e.g. 2.

If you want to work with erosion tables in a program, you
must copy Cycle 1.0 GENERATOR into the program.

CYCL DEF 1 GENERATOR

EROSION TABLE ?

MAX. POWER STAGE ?

MIN. POWER STAGE ?

5

15

2

This manual is related to the following products: