Outputting system information to the trap buffer – H3C Technologies H3C SecPath F1000-E User Manual
Page 76
65
Step Command
Remarks
3.
Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
for default channel
names.
4.
Configure an output rule for
the log host.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "
Default output rules of system
."
5.
Specify the source IP address
for the log information.
info-center loghost source
interface-type interface-number
Optional.
By default, the source IP address of
output log information is the
primary IP address of the matching
route's egress interface.
6.
Configure the format of the
time stamp for system
information output to the log
host.
info-center timestamp loghost
{ date | iso | no-year-date |
none }
Optional.
date by default.
7.
Set the format of the system
information sent to a log host
to UNICOM.
info-center format unicom
Optional.
H3C by default.
8.
Specify a log host and
configure the related output
parameters.
info-center loghost [ vpn-instance
vpn-instance-name ]
{ host-ipv4-address | ipv6
host-ipv6-address } [ port
port-number ] [ channel
{ channel-number |
channel-name } | facility
local-number ] *
By default, the system does not
output information to a log host. If
you specify to output system
information to a log host, the
system uses channel 2 (loghost) by
default.
The value of the port-number
argument must be the same as the
value configured on the log host.
Otherwise, the log host cannot
receive system information.
Outputting system information to the trap buffer
The trap buffer only receives trap information, and discards log and debug information.
To output system information to the trap buffer:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable the information center. info-center enable
Optional.
Enabled by default.
3.
Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
for default channel
names.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS