H3C Technologies H3C SecPath F1000-E - Manual (Page 173)

162
SSH server configuration examples
Password authentication enabled SSH server configuration
example
Network requirements
As shown in Figure 72 , a host (the SSH client) and SecPath (the SSH server) are directly connected
through Ethernet interfaces. Configure an SSH user on SecPath so that the host can securely log in to
SecPath after passing password authentication. Configure a username and password for the user on
SecPath.
Figure 72 Network diagram
Configuration procedure
1. Configure the SSH server.
# Generate the RSA key pairs.
system-view
[SecPath] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++
+++++
++++++++
# Generate a DSA key pair.
[SecPath] public-key local create dsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server.
[SecPath] ssh server enable