Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 208
197
Configuration procedure
# Specify the IP address of the log host.
•
Select Log Report > Syslog from the navigation tree of the SecPath and perform the following
configurations as shown in
Figure 103 Specifying the IP address of the log host
•
Enter 10.1.1.10 for Log Host1.
•
Click Apply.
# Configure customized service resources.
•
Select Resource > Service > Customized Service from the navigation tree and then click Add to
perform the following configurations as shown in
.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS