H3C Technologies H3C SecPath F1000-E - Manual (Page 194)

183
Bye
Connection closed.
SFTP server configuration example
Network requirements
As shown in Figure 83 , an SSH connection is required between the host and SecPath. The host, an SFTP
client, needs to log in to SecPath for file management and file transfer. Use password authentication and
configure the username client002 and the password aabbcc for the client on the router.
Figure 83 Network diagram
Configuration procedure
1. Configure the SFTP server.
# Generate the RSA key pairs.
system-view
[SecPath] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++
+++++
++++++++
# Generate a DSA key pair.
[SecPath] public-key local create dsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server.
[SecPath] ssh server enable
# Enable the SFTP server.
[SecPath] sftp server enable