Deactive state, Active state – H3C Technologies H3C SecPath F1000-E User Manual
Page 46
35
Figure 14 Patches that are not loaded to the memory patch area
DEACTIVE state
Patches in DEACTIVE state have been loaded to the memory patch area but have not yet run in the system.
Suppose there are seven patches in the patch file to be loaded. After the seven patches successfully pass
the version check and CRC check, they are loaded to the patch memory area and are in DEACTIVE state.
In the patch memory area, patch states are as shown in
Figure 15 Patch states in the patch memory area after a patch file is loaded
ACTIVE state
Patches in ACTIVE state run temporarily in the system and become DEACTIVE at a reboot. For example,
if you activate the first five patches in
, their states change from DEACTIVE to ACTIVE, ash sown
in
The patches in ACTIVE state change to the DEACTIVE state at a reboot.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS