Configuring the secpath – H3C Technologies H3C SecPath F1000-E User Manual
Page 160
149
3.
Check for the Remote Shell Daemon entry. If it does not exist, install the daemon first.
4.
Look at the Status column to check whether the Remote Shell Daemon service is started. In this
example, the service is not started yet.
5.
Double-click the Remote Shell Daemon service row, and then in the popped up Remote Shell
Daemon Properties window, click Start to start the service, as shown in
Figure 70 Remote Shell Daemon Properties window
Configuring the SecPath
# Configure a route to the remote host. The configuration procedure is omitted.
# Set the time of the host remotely.
Trying 192.168.1.10 ...
Press CTRL+K to abort
The current time is: 6:56:42.57
Enter the new time: 12:00
12:00
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS