Network requirements – H3C Technologies H3C SecPath F1000-E User Manual
Page 175
164
Figure 73 Specifying the host name (or IP address)
In the window shown in
, click Open to connect to the server. If the connection is normal,
you will be prompted to enter the username and password. After entering the username (client001)
and password (aabbcc), you can enter the configuration interface of SecPath.
Publickey authentication enabled SSH server configuration
example
Network requirements
As shown in
, a host (the SSH client) and SecPath (the SSH server) are directly connected
through Ethernet interfaces. Configure an SSH user on SecPath so that the host can securely log in to
SecPath after passing publickey authentication. Use the RSA public key algorithm.
Figure 74 Network diagram
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS