H3C Technologies H3C SecPath F1000-E - Manual (Page 68)

57
Table 6 Severity description
Severity Severity value Description
Corresponding keyword
in commands
Emergency 0 The system is unavailable. emergencies
Alert 1 Action must be taken immediately. alerts
Critical 2 Critical condition. critical
Error 3 Error condition. errors
Warning 4 Warning condition. warnings
Notice 5 Normal but significant condition. notifications
Information 6 Informational messages. information
Debug 7 Debug messages. debugging
Output channels and destinations
Table 7 shows the output channels and destinations.
The system supports ten channels. By default, channels 0 through 6, and channel 9 are configured with
channel names and output destinations. You can change these default settings as needed. You can also
configure channels 7 and 8 and associate them with specific output destinations as needed.
Configurations for each output destinations function independently and take effect only after the
information center is enabled.
Table 7 Information channels and output destinations
Information
channel number
Default
channel name Default output destination Description
0 console Console
Receives log, trap and debugging
information.
1 monitor Monitor terminal
Receives log, trap and debugging
information, facilitating remote
maintenance.
2 loghost Log host
Receives log, trap and debugging
information and information will be
stored in files for future retrieval.
3 trapbuffer Trap buffer
Receives trap information, a buffer
inside the device for recording
information.
4 logbuffer Log buffer
Receives log and debugging
information, a buffer inside the device
for recording information.
5 snmpagent SNMP module Receives trap information.
6 channel6 Web interface Receives log information.
7 channel7 Not specified
Receives log, trap, and debugging
information.