Executing the tracert operation at the cli, Prerequisites – H3C Technologies H3C SecPath F1000-E User Manual
Page 19
8
Figure 5 Page for executing the tracert operation
2.
Enter the IP address or host name of the destination device in the Trace Route field.
3.
Click Star.
The Summary box displays the tracert operation result.
Figure 6 Tracert operation result
Executing the tracert operation at the CLI
Prerequisites
•
Enable sending of ICMP timeout packets on the intermediate devices (the device between the
source and destination devices). If the intermediate devices are H3C devices, execute the ip
ttl-expires enable command.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS