Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 92)

6.2 Block diagram
6 Wiring
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-2
6.2 Block diagram 6200 Block diagram 6- ][Verdr_Blockschalt_DD5
The following block diagram provides an overview of the wiring of the
servo amplifier. The wiring of the expansion cards is not shown.
The block diagram also shows the position and type of shield connec-
tions, the PE and the connections of the attached device to the mount-
ing plate.
*) Please note: If you are using an external brake resistor, remove the link
between Pin 4 and 5 on X8.
Sym-
bol Connec-
tion Description
X1, X2, X6,
X9 Shield in the connector housing
X3, X8 Shield on the front plate
PE Protective earth, PE
Mounting
plate Wide area, electrical connection between the designat-
ed device and the mounting plate in the control cabinet