Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 63)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-35
4.4 Expansion cards
4 Function description
4.4 Expansion cards 4400 Expansion cards 4-
4.4.1 Expansion card I/O-14/08
Expansion card I/O-14/08 4- ][Funktion_Erw_I_O_14_8_protego_D
The expansion card I/O-14/08 is available as an accessory.
Functions:
 14 additional digital inputs and 8 digital outputs
 The function of the inputs and outputs can be configured in the com-
missioning software.
 The inputs initiate the motion tasks that are stored in the servo ampli-
fier.
 The outputs signal the status of the integrated position controller to
the higher level control system.
 The functions of the inputs and outputs correspond to the functions
that can be assigned to the digital inputs and outputs on connector
X3 of the servo amplifier.
 The inputs and outputs are isolated from the servo amplifier through
optocouplers.
Fig. 4-11: Front view of expansion card I/O-14/08
LEDs:
Enter the motion block number (example)
The functions can be configured in the commissioning software. The ta-
ble overleaf shows the default settings.
LED Description
Green 24 V supply voltage is present
Red Fault on the expansion card's outputs (overload and/or short
circuit)
Motion block
number A7 A6 A5 A4 A3 A2 A1 A0
Binary 1010
1110 1 0 1 0 1 1 1 0
Decimal 1 74 128 - 32 - 8 4 2 -