Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 112)

6.7 Control element
6 Wiring
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-22
6.7 Control element 6700 Control element 6-
6.7.1 Supply voltage 24 VDC
Supply voltage 24 VDC 6- ][Verdr_Leiterquerschnitte_Verweis
Under “Connection cables”, please note the requirements for the:
 Cable cross sections
 Insulation material
Verdr_Versorgung_Warnung
][Verdr_Versorgung_24_V_DD5
][Verdr_Versorgung_24_V_protego_Sicherung_DD5
Use the following fuses.
WARNING!
Electric shock!
Safe electrical isolation must be ensured for the external power
supply that generates the supply voltage. Failure to do so could
result in electric shock. The power supplies must comply with
EN 60950-1, 05/2006, EN 61558-2-6, 11/1997.
Connector pin assignment
Connector X4 Pin Designation Description
1 +24 V Supply voltage + 24 VDC
2 +24 V Supply voltage + 24 VDC
3 DGND Earth for supply voltage
4 DGND Earth for supply voltage
Connection
Connected internally:
Pin 1 and 2 (24 V)
Pin 3 and 4 (DGND)
24 V connection isolated from exter-
nal power supply, e.g. with isolating
transformer
Noise suppression filters integrated
within the servo amplifier
Fuse
Device type All Type
Blow-out fuse or similar Max. 8 AF Fine wire fuse or
circuit breaker
X4
+24 V 1
DGND 3
+24 V 2
DGND 4
STO-ENABLE 5
4
L3
1
Servo Drive X4
L1
L2
2
+24 V
DGND
PE
+24 V +24 V
DGND
3