Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 107)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-17
6.6 Power element
6 Wiring
Use the following fuses for F
N1
, F
N2
and F
N3
, depending on the device
type.
US types in brackets
x = S or S-R for mains voltage 480 V
x = N or N-R for mains voltage 230 V
6.6.2 Motor with brake
Motor with brake 6- ][Verdr_Leiterquerschnitte_Verweis
Under “Connection cables”, please note the requirements for the:
 Cable cross sections
 Insulation material
][Verdr_Motor_protego_D  The motor and motor holding brake are connected to the same termi-
nal on the servo amplifier. The wires can be carried within the same
cable. Note: The wires for the motor holding brake must have sepa-
rate shielding.
 The motor connection must be shielded appropriately.
Fuse
Device type 1.5 A, 3 A 6 A, 10 A
Blow-out fuse or similar 6 AT
(FRx-6) 10 AT
(FRx-10)
Connector pin assignment
Connector X9 Pin Designation Description
1 BR- Brake-
2 BR+ Brake+
3 PE Earth conductor
4 U2 Motor connection phase U
5 V2 Motor connection phase V
6 W2 Motor connection phase W
X9
PE
U2
V2
W2
BR-
BR+
3
4
5
6
1
2