Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 111)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-21
6.6 Power element
6 Wiring
Multi-axis systems
With multi-axis systems please note the specific conditions of your
plant. On multi-axis systems, servo amplifiers can be interconnected via
the intermediate circuit.
As with single-axis systems, max. cable runs can only be achieved if the
material requirements are strictly observed.
][Funktion_Zwischenkreis_DD5_Wichtig
NOTICE
High transient currents between connected intermediate circuits
can destroy the servo amplifier.
- Supply the servo amplifier from the same mains (identical
mains voltage).
- Do not wire servo amplifiers with smaller outputs between two
servo amplifiers with higher outputs.
- Ensure that the total rated currents of all the servo amplifiers
connected in parallel in an intermediate circuit is not exceeded.
 230 V series: Max. 24 A
 480 V series: Max. 40 A