Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 58)

4.3 Control element
4 Function description
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-30
4.3.7 Encoder emulation
Encoder emulation 4- ][Funktion_Encoder_Emu_X1
Output signals for a higher level position controller are generated from
signals from the resolver or a SinCos encoder. The position of the motor
shaft is calculated in the servo amplifier from the cyclical-absolute sig-
nals from the resolver or SinCos encoder:
 Signals are incremental encoder compatible
 Signals for the SSI interface
][Funktion_Encoder_Emu_ROD
Output of incremental encoder signals
Functions:
With this encoder emulation, a total of six tracks are generated from the
existing output signals from the resolver or SinCos encoder; a higher
level control system uses these tracks for positioning. These six tracks
are track A, B and NI (zero pulse) and their inverted signals A\, B\ and
NI\.
Parameter setting:
The following can be set in the “Encoder Emulation” window in the com-
missioning software:
 Position of the zero pulse within one mechanical revolution (NI-OFF-
SET parameter)
 Resolution (before multiplication) in counts/revolution
 ENCMODE = 1: Incremental encoder compatible signals from the re-
solver or SinCos encoder
 ENCMODE = 3: Encoder signal from X1 is available at X5
Parameter
ENCMODE Encoder type Resolution Zero pulse
1 = incremental encoder Resolver 256 … 4096 (2
8
... 2
12
) One per revolution (only
when A = B = 1)
SinCos encoder 256 … 524288 (2
8
… 2
19
) One per revolution (only
when A = B = 1)
3 = Incremental encoder in-
terpolation SinCos encoder 4 ... 256 (2
2
... 2
7
)
TTL counts * resolution of
encoder
Encoder signal passed from
X1 to X5