Pilz PMCtendo DD5.03/000/0/0/0/110-230VAC - Manual (Page 85)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-1
5.1 General requirements
5 Installation
55000 Installation Installation 5- 5.1 General requirements 5100 General requirements 5- ][Montage_Einbauort
Mounting location
 The servo amplifier should be installed in an enclosure, e.g. control
cabinet, that conforms to the protection class required for the envi-
ronment.
 The mounting location must be free from conductive and aggressive
materials.
 Make sure you keep the necessary space clear above and below the
servo amplifier (see section entitled “Installing the servo amplifier”)
][Montage_Umgebung
Environmental conditions
 When installing the system in an enclosure such as a control cabinet,
the environmental data for the servo amplifier must be taken into ac-
count. Details can be found in the chapter entitled “Technical Details”.
 Protect the servo amplifier from undue stress. In particular, do not al-
low any components to become bent and/or insulation distances to
be modified during transportation and handling.
 Make sure there is an adequate flow of cool, filtered air from the bot-
tom of the control cabinet or use a heat exchanger. Please note the
ambient temperature of
0 - 40 °C with nominal data, 40 - 55 °C with
power derating 2.5 %/K.
 In extreme ambient conditions, additional measures may be required
in order to keep within the prescribed value range.
][Montage_Erdung
Earthing, EMC
 Make sure that the servo amplifier and motor are earthed correctly.
Do not use varnished (non-conductive) mounting plates.
 Components that generate magnetic fields should not be installed di-
rectly next to the servo amplifier. If necessary, shield the magnetic
fields.
][Montage_Entladung  Damage due to electrostatic discharge!
Electrostatic discharge can damage components. Ensure discharge
before touching the servo amplifier, e.g. by touching an earthed, con-
ductive surface or by wearing an earthed armband.
][Montage_Netzteil
Power supply
 The servo amplifier and power supply should be installed close to
each other on the conductive,
earthed mounting plate inside the con-
trol cabinet.
][Montage_Schaltschrankbeleuchtung
Control cabinet lighting
 Use low interference panel lighting for inside the control cabinet.