Demonstrations-modus, Demonstration mode, Demonstrations-mod us – Panasonic NVVX30EG User Manual
Page 150: 0 mix mode (-^ 88) 0, 0 motion-sensor-controlled recording mode, Manuelles auslösen des demonstrations-modus, Ausschalten des demonstrations-modus, Manually activating the demonstration mode, Cancelling the demonstration mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/658561/150/background.png)
(D
0
m
SNAP
MIX
N
's____ ^____
0
/ s
NEGA
SOLARI
©
----------------
----------------
0
^---------- —-^
WIPE
STROBE
GAIN UP
.
^
J
Panasonic
SEPIA
©
B/W
0
STDBY
MOTION SENSOB
DEUTSCH
ENGLISH
m
Aufnahmemodus Schnappschuß (-» 78)
0 Überblendmodus Mix (*^ 88)
0 Überbiendmodus Wipe
(-*
90)
0 Aufnahmemodus Stroboskop H 92)
0 Aufnahmemodus Aufhellung (•» 94)
0
Aufnahmemodus Negativ
{•*
94)
0 Aufnahmemodus Solarisation (>e 94)
0
Aufnahmemodus Sepia
{•*
94)
0
Aufnahmemodus Schwarzweiß 94)
0 Bewegungssensorgesteuerter Aufnahmemodus
H 9 6 )
0 Demonstrations-Modus
Demonstrations-Modus
Wenn Sie den Netzadapter an den Camerarecorder
anschließen, den Cartierarecorder einschalten, ohne daß
eine Cassette eingesetzt ist, und ihn ohne Auslösen
irgendeiner Funktion ca. 10 Minuten eingeschaltet
lassen, schattet er automatisch auf den
Demonstrations-Modus um. Der Camerarecorder bleibt
so lange in diesem Modus, bis Sie ihn ausschalten und
den Netzadapter von ihm trennen.
■ Manuelles Auslösen des
Demonstrations-Modus
Die Taste [PLAY/DISPLAY SELECT] gedrückt halten
und gleichzeitig den Schalter [POWER] nach außen
drehen. Der Demonstrations-Modus startet 6 Sekunden
später.
■ Ausschalten des
Demonstrations-Modus
Den Schalter [POWER] nach innen drehen, um den
Camerarecorder auszuschalten. Diesen Schalter
anschließend wieder nach außen drehen, während Sie
die Taste [STOP/T.SEL.] gedrückt halten.
0 Snapshot Recording Mode (-►78)
0 Mix Mode (-^ 88)
0
Wipe Mode (-►90)
0 Strobe Mode (-► 92)
0
Gain-up Mode
{-*
94)
0
Negative Mode (-► 94)
0 Solarisation Mode (-► 94)
0
Sepia Mode (-► 94)
0
BiacK-and-White Múde (-► 94)
0 Motion-Sensor-Controlled Recording Mode
(-►96)
0 Demonstration Mode
Demonstration Mode
If you connect the AC Adaptor to the Movie Camera, turn
the Movie Camera on without any cassette inserted, and
leave it on for approximately 10 minutes without
performing any operation, it automaticcilly switches over
to the Demonstration Mode. The Movie Camera remains
in this mode until you turn it off and disconnect the AC
Adaptor.
■ Manually Activating the Demonstration
Mode
While pressing the [PLAY/DISPLAY SELECT] Button,
turn out the [POWER] Switch. The Demonstration Mode
starts after 6 seconds.
■ Cancelling the Demonstration Mode
Turn in the [POWER] Switch to turn the Movie Camera
off. Then turn it out again while pressing the
[STOP/T.SEL] Button.
-
150
-