Manually setting the injection point (x alignment) – Bio-Rad ChromLab™ Software User Manual
Page 217

Customizing the Trace Table Display
User Guide
| 215
Manually Setting the Injection Point (x Alignment)
You can manually set the injection point for any run, including a run displayed in a
trace comparison. The injection point is saved with the run (the x = 0 point). A
change to the injection point in one view affects other views that include the run.
To set the injection point for a run manually
1.
Select Analysis > Set Injection Point.
2.
In the Set Injection Point dialog box, type the new injection point.
3.
If several runs are open in the same window, select a run on the Run menu.
4.
Click Apply to align the data according to the setting you typed or click Reset to
restore the original setting.
This manual is related to the following products: