Creating a method from standard phases – Bio-Rad ChromLab™ Software User Manual
Page 167

Creating a Method from Standard Phases
User Guide
| 165
6.
Do one of the following:
Select a project folder. In the Method Name box, type a name for the
method, and then click Save.
Click New SubProject or New Root Project and type a name for the new
project in the Enter Project Name box that appears above the Projects
pane. Click Save.
Creating a Method from Standard Phases
When you create a method from standard phases, you specify in the Phase
Parameters pane the general settings that will apply to the entire method. These
settings include column selection, pressure limits, flow rate, method base, pH,
fraction collector rack type, and fraction volume. The parameters available in this
pane vary depending on the devices present in the fluidic scheme. For example, pH
is available only when the pH valve is present.
The workflow for creating a method from standard phases is as follows:
Creating a method.
Selecting a fluidic scheme.
Important:
The fluidic scheme must match the configuration of the NGC
instrument. If it does not, change the fluidic scheme or create a new one to
match the NGC instrument configuration. See
Adding phases to the method by dragging them from the Phase Library
pane to the Method Outline pane in any position below the Method
Settings phase.
Editing the properties of the phases.
Saving the method.