Bio-Rad ChromLab™ Software User Manual
Page 144

5
| Method Editor
142
| NGC Chromatography Systems and ChromLab Software
You can change the port on the sample inlet valve from which to load sample (the
system defaults to Port 1). You can also choose to prime the tubing with sample
before application. If you select this checkbox, you can define the flow rate and
sample volume with which to prime.
Finally, you can choose to interrupt injection if air is detected. If you select this
checkbox and air is detected in any of the lines connected to air sensors set to
detect end of sample, the system stops the sample pump and the method
continues to the next step.
This manual is related to the following products: