Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 86)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
78 / SYSTEM CONFIGURATION
To activate Precharge:
1. At the Control Channel screen, enter a Precharge time. A Precharge
Time must be entered before the Precharge Ground Speed feature
displays on the Ground Speed Setup screen (Refer to Ground Speed
Setup section).
2. Press the Work Screen button and select the Speed Set button.
3. Enter a Precharge Ground Speed greater than 0.
IMPORTANT: Turn the master switch ON to activate the Precharge
feature.
NOTE: The master switch must be ON
to activate the Precharge
feature.
Delay Time
IMPORTANT: A Delay Time number MUST be entered as a negative
number (-5.0 seconds) for the system to identify
between a Delay Time or Precharge state.
With an Implement Lift Switch
Delay Time determines the length of time before the control channel will
start after the master switch has been turned ON and the implement switch
is in a lowered position.
• The system will immediately shutdown the channel when the
implement lift switch is in the raised position.
• The system will delay the channel shutdown if the master switch is
turned OFF and the implement is in the down position.
Without an Implement Lift Switch
When the Delay Time feature is utilized without an implement lift switch:
• The control channel will delay after the master switch has been turned
ON.
• A delay will also occur and then shutdown the control channel when
the master switch is turned OFF.
NOTE: Delay Time functionality may
work differently than described
above if the system has been
purchased direct from the
original equipment
manufacturer. Refer to the
manufacturer’s operator
manual for further instruction.
Flush Enable
Flush Enable is a manual override mode that opens the valve and
dispenses granular fertilizer, granular seed, or liquid material for a period of
time in relation to a user-defined flush speed. The Flush Enable feature can
only be activated when the tractor is stopped.
To activate Flush Enable:
1. Change Flush Disable to Enable. Flush Enable must be activated
before the Flush Ground Speed feature displays on the Ground Speed
Setup screen.
2. A Flush Ground Speed greater than 0 must be entered on the Ground
Speed setup screen for this feature to operate.