Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 135)

OPERATOR’S MANUAL
11001-1501-200811
11001-1501-200811
DATA ITEMS / 127
DATA ITEMS
NOTE: Data Items on the Main Work
screen with a check box allows
the number to be reset to zero.
Data items are selected at Screen Configuration. The following illustrates
available display parameters and their respective functions. Display
parameter placement can be moved to display on the Main Work screen to
individual preferences. Refer to System Configuration for additional
information on setting parameters.
CLEARING ACCUMULATORS
Some Data Item values can be reset to zero from the Main Work screen.
Accumulator displays (e.g., Area 1 Field, Seed Count, etc.) on the active
screen can be reset to zero by placing a check mark in the box next to the
data item. Only accumulators that are on the currently-displayed screen can
be reset. Accumulators are reset independently. They can only be reset
when the master switch is OFF. Once an accumulator has reached its
maximum value, it will roll over to 0.0.
CONTROL ACTUAL CHANNELS 1-4
NOTE: All Data Items are selected
from Screen Configuration.
Refer to the Screen
Configuration section for
setup instructions.
Control Actual Channels 1 - 4 display the channel actual application rates in
its respective units depending on channel setup. The channel increment/
decrement or preset table rate value also displays. When the master switch
is OFF, the target rate displays in a small font for the channel. When the
master switch is ON, the rate displays in a large font and is the actual
application rate. When the channel’s target rate is adjusted with the Inc/Dec
or rate table function, the new target rates display for 5 seconds, followed
by the actual rate. This Data Item will display on an entire row of the
Work screen.
CONTROL TARGET CHANNELS 1-4
Control Target Channels 1 - 4 display the channel target set rates
depending on channel setup. The channel Inc/Dec value or preset table
rate also displays. When the master switch is OFF, the rate displays in a
small font. When the master switch is ON, the rate displays in a large font.
This Data Item will display on an entire row of the Work screen.
C O R N CH1
Rate 1
40.5 KS
AC
Rate 1
40.5
AC
C O R N CH1
Rate 1
40.5
KS
AC
*