Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 - Manual (Page 19)

OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
INSTALLATION / 11
3. Connect any additional adapter harnesses to the module harness. The
WSMT Module harness can accept the following adapter harnesses:
– Actuator Harness: This harness allows for up to 4 output control
channels, 4 control channel feedbacks, a hopper level sensor input,
a shaft sensor input, a ground speed input, and an implement
switch input. In addition, a pair of 6-pin connectors are available for
Servo connection which use FB1/FB2 respectively. Install sensors,
valves, etc. per the instructions included with the items. Install the
PWM valve assembly and feedback sensor for each control loop
and connect the devices to their respective inputs on the harness,
making certain to match PWM 1/Servo 1 with FB 1, PWM 2/Servo 2
with FB 2, etc. Secure any unused and excess cable lengths where
necessary. Refer to (
Figure 15 ) for additional information.
– Seed Sensor Harness: This harness accommodates any standard
Dj Seed Sensor harness (PM style) or SE style harness depending
on the WSMT harness. A wide variety of harnesses are available to
accommodate various numbers of sensor inputs. Install all seed
sensors per the instructions included with the individual sensors.
Secure any unused or excess cable lengths as necessary.