Operator’s manual, Valve calibration - gran seed and gran fert – Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 User Manual
Page 79
OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
SYSTEM CONFIGURATION / 71
VALVE CALIBRATION - GRAN SEED AND GRAN
FERT
The Valve Calibration screen sets the machine hydraulic system
parameters and should be performed for best results. Each control channel
that is enabled requires a valve calibration.
Press the Valve Calibration button to access the Valve Calibration screen.
Figure 44
Control Channel Calibration Screen - Gran Seed and Gran Fert
CHANNEL ON
The Channel On button appears on this screen only if the channel is turned
off. The channel must be ON before performing a valve calibration. Press
the Channel On button to turn the channel on.
When the START key is engaged, the machine will become
operational. All necessary precautions must be taken to ensure
user safety. Failure to practice all necessary caution may result in
serious injury or death.
Hoppers are assumed to be empty for this calibration. If they are
loaded, material will be dispensed onto the ground.
To perform the Control Channel Valve Calibration:
1. Move the implement to the “raised” position.
2. Apply the tractor brakes and lock in the applied position.