Intelliag, Troubleshooting & alarms, Operator’s manual – Great Plains DICKEY-john IntelliAg Planter-Drill Control L3 User Manual
Page 169
OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1501-200811
TROUBLESHOOTING & ALARMS / 161
TROUBLESHOOTING & ALARMS
Alarms are indicated on the Virtual Terminal with the following graphic, as
well as with a continuous, audible alarm. The audible alarm is terminated by
pressing the Alarm Cancel button or ESC key. In addition, detailed
descriptions of the current alarm can be viewed by pressing the Alarm
Detail button. Some of the alarm conditions display instructions on
correcting the situation.
Alarms are presented in a full screen display that will describe the alarm
and, depending upon the alarm, may give instructions on how to fix the
alarm. Each alarm type has an associated alarm number that can be
cross-referenced in this section.
Some alarms (for instance a Master Switch alarm) will require a specific
action before the alarm condition will cease. In these cases, the instructions
to proceed are indicated in the alarm display.
The following table describes the possible alarm conditions, causes, and
remedies.
IntelliAG
212